Search the whole station

Precautions during sprocket processing

144
sprocket wheel - Precautions during sprocket processing

Sprocket wheel will have some problems in the production process, if it is a big problem then the loss will be very large, small problems to save is also better, and these problems in the usual production process can be avoided as much as possible, so for us in the production process of the factory, the less problems, the better.

Before the sprocket wheel production must be prepared raw materials, raw materials are important, there is no raw materials to talk about production, for us is the need to pay attention to this problem, in such a situation is very good, in the raw materials above also need to pay attention to the preservation of the environment, this will not lead to loss.

In the process of production must pay attention to the problem of safety, safety is the key, in the production of safety means to lose less, for us are better, safety can not be ignored, this can play a better effect.

After production, products need to be tested, and product testing needs everyone to pay attention to, testing can reduce the unqualified rate, for us this may get better products, in the market sales is also very good.

In the process of using the sprocket wheel, its tightness should be appropriate, too tight will increase power consumption, bearing easy to wear; Too loose the sprocket wheel is prone to jumping and detaching. The tightness of the sprocket is: lifted or pressed from the middle of the sprocket, about 2%-3% of the center distance of the two sprockets. Sprockets mounted on the shaft should not swing and skew.

When the sprocket wheel is seriously worn, the new sprocket wheel and the new sprocket wheel should be replaced at the same time to ensure good engagement. The new sprocket wheel is too long or stretched after use, difficult to adjust, depending on the situation to remove the chain, but must be even. The sprocket wheel should be filled with lubricating oil in time during work. When the machine is stored for a long time, the sprocket wheel should be removed and cleaned with kerosene or diesel oil, and then coated with oil or butter and stored in a dry place

The prev: The next:

Related recommendations

Send Inquiry
*
*
*
正在提交中....
提交成功!
提交失败!请稍后再试
邮箱错误!
电话错误!
Expand more!
Consulting Product List
Consulting Product List Submit consultation for the above products
Consulting Product List